public virtual void DrawArc(
	int x,
	int y,
	int width,
	int height,
	int startAngle,
	int arcAngle
)

Public Overridable Sub DrawArc ( 
	x As Integer,
	y As Integer,
	width As Integer,
	height As Integer,
	startAngle As Integer,
	arcAngle As Integer
)

public:
virtual void DrawArc(
	int x, 
	int y, 
	int width, 
	int height, 
	int startAngle, 
	int arcAngle
)

abstract DrawArc : 
        x : int * 
        y : int * 
        width : int * 
        height : int * 
        startAngle : int * 
        arcAngle : int -> unit 
override DrawArc : 
        x : int * 
        y : int * 
        width : int * 
        height : int * 
        startAngle : int * 
        arcAngle : int -> unit 

Parameters

x

Type: SystemInt32
An int which contains the x-coordinate of the upper-left corner of the rectangle that defines the ellipse.

y

Type: SystemInt32
An int which contains the y-coordinate of the upper-left corner of the rectangle that defines the ellipse.

width

Type: SystemInt32
An int which contains the width of the rectangle that defines the ellipse.

height

Type: SystemInt32
An int which contains the height of the rectangle that defines the ellipse.

startAngle

Type: SystemInt32
An int which specifies the angle in degrees measured clockwise from the x-axis to the starting point of the arc.

arcAngle

Type: SystemInt32
An int which specifies an angle in degrees measured counter-clockwise from the startAngle parameter to the ending point of the arc.

startAngle = 0 is equivalent to the 3-o'clock position.

DrawArc draws the arc from startAngle to startAngle+arcAngle. A positive arcAngle indicates a counter-clockwise rotation. A negative arcAngle implies a clockwise rotation.

Reference